Citat: If you want to prepare the crystals for transdermal use, you need to remove the ester group. The supplies you need are sodium hydroxide, distilled water, and methanol. Dissolve the testosterone crystals in a minimun amount of methanol. In a separate container, dissolve 1/8 teaspoon of sodium hydroxide in 8 oz of hot distilled water. Once dissolved, add the sodium hydroxide solution to the methanol/test solution. This will turn white instantly. Let this react for a few minutes. Next add an additional 8 oz of water, to make sure all the salt that was formed is dissolved. The white stuff you see is pure unesterfied testosterone, and it should be filtered out. You should run water over the testosterone while it is on the filter to make sure all of the salts and hydroxides are removed. Ideally you would test the pH of the test to make sure all of the hydroxides are rinsed off.
Dette er for propionate. Her tager de så ikke højde for at det er opløst i x ml olie. Jeg kunne forstille mig, at når du tilsætter din opløsning til NaOH, så vil der dannes sæbe og gøre processen endnu mere kompliceret. Så længe du ikke har det i raw powder, så er det nok lidt op a' bak! (:
|
